Our Impact Protection screen protectors are cleanable and can be washed by water then reapplied.
Any kind of lint or particle stuck on the adhesion can be washed away.
In order to clean a RhinoShield Impact Protection Screen Protector, please follow these few steps:
- If the RhinoShield Impact Protection Screen Protector is on your phone, please take it off. You should use the stickers provided or any kind of tape to make sure you do not damage the adhesive with your fingernails if needed.
- Let water pour down on the whole screen protector's two sides and make sure you remove every piece of dust and anything else that could prevent it from sticking again. Tap water is fine.
- In order to dry it, please do not rub anything against it. Please simply shake it in the air with your fingers 10-20 seconds. It will remove most of the water.
- Reapply while still wet. You will be able to remove the bubbles later with the squeegee.
Our 9H Tempered Glass and Impact Flex Screen Protectors are unfortunately not cleanable. If, however, in the event of it collecting dust on the adhesion side, please be sure to contact us.